IJERT-EMS
IJERT-EMS

Aluminium Composites Materials using Stir Casting Process: Challenges and Opportunities


Aluminium Composites Materials using Stir Casting Process: Challenges and Opportunities
Authors : Sonu Kumar, Dhruv Kumar
Publication Date: 03-06-2015

Authors

Author(s):  Sonu Kumar, Dhruv Kumar

Published in:   International Journal of Engineering Research & Technology

License:  This work is licensed under a Creative Commons Attribution 4.0 International License.

Website: www.ijert.org

Volume/Issue:   Volume. 4 - Issue. 06 , June - 2015

e-ISSN:   2278-0181

 DOI:  http://dx.doi.org/10.17577/IJERTV4IS060066

Abstract

This paper studies the effect of aluminium base metal with the different percentage of reinforcement of SiC(3,6,9) and Cu(0.5,0.75,1) with Mg (2 gram) in each. The basic reason of metal reinforced is to improve the properties then its original materials like hardness, cutting force, etc. The paper content of experimental work as stir casting process and preparation of aluminium matrix composites material by using aluminium as matrix form and Sic and Cu as reinforcement by varying proportion. Here hardness decreases on increase percentage of reinforcement. X-Ray Diffraction test shows degree of angle is between 35 to 45. Scanning Electron Microscope test shows electron variation at different magnification it also shows the distribution of Sic and cu particles in aluminium alloy.

Citations

Number of Citations for this article:  Data not Available

Keywords

Key Word(s):    

Downloads

Number of Downloads:     538
Similar-Paper

Call for Papers - May - 2017

        

 

                 Call for Thesis - 2017 

     Publish your Ph.D/Master's Thesis Online

              Publish Ph.D Master Thesis Online as Book