IJERT-EMS
IJERT-EMS

Modelling and Analysis of SEPIC using DVR for Solar PV System


Modelling and Analysis of SEPIC using DVR for Solar PV System
Authors : Bhogapurapu Gayatri Subhadra, Srungarapu Naga Venkata Ganesh
Publication Date: 01-02-2016

Authors

Author(s):  Bhogapurapu Gayatri Subhadra, Srungarapu Naga Venkata Ganesh

Published in:   International Journal of Engineering Research & Technology

License:  This work is licensed under a Creative Commons Attribution 4.0 International License.

Website: www.ijert.org

Volume/Issue:   Volume. 5 - Issue. 02 , February - 2016

e-ISSN:   2278-0181

 DOI:  http://dx.doi.org/10.17577/IJERTV5IS020014

Abstract

Dynamic Voltage Restorer (DVR) is a series controller which has capability to control voltage profile at the load end under all operating conditions. The device is mainly used in distribution system with low and medium voltages. The controller has now much importance (due to its capability in maintaining power quality) as most of the loads are becoming very sensitive to power quality events like voltage sags, swells etc. However energy storage requirement has put limitations on high power rating of DVR. This project tries to find a solution to energy storage limitations: renewable sources. The project proposes modelling of PV array, Single Ended Primary Inductive Coil (SEPIC)/Boost converter for mitigating voltage disturbances using DVR. Performance of DVR will be investigated using motor load.

Citations

Number of Citations for this article:  Data not Available

Keywords

Key Word(s):    

Downloads

Number of Downloads:     183
Similar-Paper

Call for Papers - May - 2017

        

 

                 Call for Thesis - 2017 

     Publish your Ph.D/Master's Thesis Online

              Publish Ph.D Master Thesis Online as Book