IJERT-EMS
IJERT-EMS

Development of Microwave Ridged Horn Antenna using DFMA Approach


Development of Microwave Ridged Horn Antenna using DFMA Approach
Authors : Dr. Lachiram, ES Suraj, Dr. Soni JS
Publication Date: 01-10-2016

Authors

Author(s):  Dr. Lachiram, ES Suraj, Dr. Soni JS

Published in:   International Journal of Engineering Research & Technology

License:  This work is licensed under a Creative Commons Attribution 4.0 International License.

Website: www.ijert.org

Volume/Issue:   Volume. 5 - Issue. 10 , October - 2016

e-ISSN:   2278-0181

 DOI:  http://dx.doi.org/10.17577/IJERTV5IS100022

Abstract

Design for manufacture and assembly (DFMA) is aimed at improving the product quality at the mean while reducing the cost and time to manufacture using some laid down structured approach. Antenna is a device which converts electronic signals into electromagnetic waves or vice versa. Microwave antennas used in Electronic Warfare (EW) applications are smaller in size to cater to the smaller wave length. DFMA is one of the few methods available which leads to design optimization on point of view of manufacturing. By adopting DFMA, the design of ridged horn antenna (RHA) is optimized against ease of manufacture and assembly upholding the functional requirement. The paper focuses on the application of DFMA to Electronic Warfare Antennas under development in an R&D environment where the quantity of production is limited and the desired design intends has to be strictly adhered to in a short time frame. The development of Ridged Horn Antenna using DFMA approach is discussed.

Citations

Number of Citations for this article:  Data not Available

Keywords

Key Word(s):    

Downloads

Number of Downloads:     79
Similar-Paper

Call for Papers - May - 2017

        

 

                 Call for Thesis - 2017 

     Publish your Ph.D/Master's Thesis Online

              Publish Ph.D Master Thesis Online as Book