Performance Analysis Of Hybrid Optical OFDM System With High Order Dispersion Compensation

Performance Analysis Of Hybrid Optical OFDM System With High Order Dispersion Compensation

Student, University College of Engineering, Punjabi University, Patiala, India.

Abstract

Orthogonal frequency division multiplexing (OFDM) is an attractive modulation format that recently received a lot of attention in the fiber-optic community. The main advantage of optical OFDM is that it can cope with virtually unlimited amount of inter symbol interference (ISI). In high-speed optical transmission systems, ISI is caused for instance by chromatic dispersion and polarization mode dispersion (PMD),which are serious issues in long-haul systems whose bit rate is higher. High order dispersion such as a third-order and higher-order dispersion effects are not fully compensated using the traditional dispersion compensating devices such as Dispersion compensating fiber (DCF). Thus the received signals at the receiver end would be distorted dramatically, even if only a small outside effect affects the transmission link. The tunable adaptive equalizer (TAE) system is proposed in this work at the receiver end to recover higher-order dispersion which would not be compensated by DCF fiber.

1. Introduction

   Orthogonal frequency division multiplexing (OFDM) has been widely employed into numerous digital standards for broad-range of applications such as digital audio/video broadcasting and wireline/wireless communication systems [1]. Many key merits of the OFDM techniques have been studied and proven in the communications industry. Firstly, the frequency spectra of OFDM subcarriers are partially overlapped, resulting in high spectral efficiency. Secondly, the channel dispersion of the transmission system is easily estimated and removed, and thirdly, the signal processing in the OFDM transceiver can take advantage of the efficient algorithm of FFT/IFFT with low computation complexity. Recently, an equivalent optical-domain multi-carrier format, called coherent optical OFDM (CO-OFDM) has been proposed for

   long haul transmission [2].Dispersion-compensating fiber is one of the dispersion management methods to recover signals after a period of distance. However, dispersion slop compensation and wavelength division multiplexing transmission is very hard to fully compensate especially for very high date rate (e.g., OFDMA) signals. Therefore, the equalizer system which included two main devices, which are phase modulator followed by a dispersive element, is used before receiver. The equalizer is used to compensate not only group velocity dispersion, but also for third- or fourth-order dispersion [3,4].

   The distribution of power among the longitudinal modes of the laser fluctuates and, as a consequence of the chromatic dispersion in the fiber, causes an amplitude fluctuation of the signal at the decision circuit in the receiver. The effect is in essence a pulse- delay fluctuation, and the error rate cannot be reduced by increasing the received signal power. By using the proposed Dispersion adaptive equalizer, the zero dispersion can be shifted to the minimum-loss window at 1550nm, while the dispersive effects do not suppress completely in the operating wavelength region because of the non-zero dispersion slop.

   Coherent Optical OFDM (CO-OFDM) is considered an enabling technology of the next generation optical communication system [5]. As a coherent system, the CO-OFDM system maintains both signal amplitude and phase [6], thus increasing bandwidth utilization. The coherent optical communication system makes full compensation of chromatic dispersion, after optical/electrical conversion, possible. Optical frequency division multiplexing (OFDM) is an attractive modulation scheme that recently received a lot of attention in the fiber optic community. OFDM is a multicarrier transmission technique where a data stream is carried with many lower rate subcarrier tones that is high bit rate data stream is divided into several low bit rates streams that are simultaneously modulated onto orthogonal subcarriers. The OFDM modulation scheme also leads to a high spectral efficiency because

   of its partially overlapping subcarriers [5].Moreover, the cyclic prefix code of the COOFDM system makes the system more resistant to inter-symbol interference caused by chromatic dispersion and polarization mode dispersion (PMD) [5, 7].

2. System Setup

   The optical transmission link with & without equalizer compensation by using single channel CO-OFDM system is setup by using a commercial fiber optics system simulation tool, OptiSystem and is shown in fig.4. It has been used by many researchers to simulate the fiber nonlinearity and dispersion effects in optical communication systems [7], [8]. Simulation setting takes most key optical communication system/component parameters into account including fiber nonlinearity, noise, dispersion, and PMD, etc. A generic CO-OFDM system includes five basic functional blocks: OFDM transmitter, RF to optical (RTO) up-converter, optical link, optical to RF (OTR) down-converter, and OFDM receiver. Figure 1 demonstrates a 10 Gbps coherent 512-subcarrier 4- QAM OFDM system; however the input data for the OFDM modulator can have different modulation formats such as BPSK, QPSK, QAM, etc. At the transmission block, both modulation and multiplexing are achieved digitally using an inverse fast Fourier transform (IFFT). The subcarrier frequencies are mathematically orthogonal over one OFDM symbol period. A CW laser and two Mach-Zehnder modulators are used to up-convert the RF data to the optical domain. The signal is then propagated through the optical link and becomes degraded due to fiber impairments. A coherent receiver with a local oscillator is used to down-convert the data to the RF domain, and finally data is demodulated and sent to the detector and decoder for BER measurements.

   Fig 1: Optical OFDM system with Mach-Zehnder modulator

   The data transmission bit rate is 10 Gbps. On the transmitter side, a bit stream is generated using a pseudo random binary sequence generator, and the data is mapped by a 16-QAM encoder. The information stream is further parsed into 512 low speed parallel data subcarriers and processed by the IFFT processor. Cyclic prefix is added to ensure a correct data recovery. The 25 Gbaud rate OFDM in-phase and quadrature parts then pass the low pass filter. The MachZehnder modulator is used to convert electrical signals to optical signals. The laser line width is set at 0.15MHz, with adjustable launch power. The frequency of the carrier wave is set at 193.1THz. The optical channel consists of 10 spans of 60km single mode fiber (SMF), with attenuation = 0.2dB/km, dispersion = 16 ps/nm/km. Amplified spontaneous emission (ASE) noise is reduced by an optical filter at the receiver. The local oscillator (LO) laser is assumed to be perfectly aligned with power set at -2dBm and line width equals to 0.15 MHz. The I/Q components of the OFDM signal is recovered by a 90 degree optical hybrid and two pairs of photo-detectors. Photo-detector noise, such as thermal, shot noise, dark current and ASE noise are included in the simulation. The converted OFDM RF signal is demodulated using FFT processor and the guarding interval is removed. The obtained signals are fed into a 4-QAM decoder. Transmission bits are collected and bit error ratio (BER) is calculated for both the system having equalizer and compared at the end of the receiver.

3. SYSTEM DESIGN USING OPTISYSTEM Optical OFDM based on coherent detection is depicts in Figure 2, 3 and 4.

   Figure 2: Optical OFDM Transmitter

   Figure 3: Optical Transmission ink.

   Figure 4: Coherent Detection of Optical OFDM

   In OOFDM system, the transmitter model is consisted of two parts, the first part is the radio frequency (RF) transmitter and the second one is optical transmitter.

   The role of the optical transmitter is to convert the electrical signal into optical form, and launch the resulting optical signal into the optical fiber and also can called RF to optical up converter (RTO). The optical transmitter consists of the following components, optical source, electrical pulse generator and optical modulator as shown in Figure 3.

   The transmission link as shown in Figure 4 part is consisted of optical fiber with length of 60 km and attenuation 0.2 dB/km, which work as transmission media, optical amplifier to amplify the weak signals and optical signal with the same window of laser, this transmission link is repeated twice.

   The receiver model of this OOFDM system is consisted of two parts, the first is optical receiver, and the second one is RF receiver as shown in figure 5. The optical receiver is consisted of two blocks and also called optical to RF down converter (OTR). When the optical signal sent from laser to receiver by fiber the first block is received the signal is photodetector, which is Positive Intrinsic Negative detector with responsivity 1 A/W.

   After the optical signal converted to electrical signal and all noise is eliminated, the signal will be demodulated at the same RF frequency which was modulated, then the signal will demodulated with OFDM demodulator to extract the symbols and then decoded to get the original bits.

4. Hybrid OFDM system design

   Because of huge advantages of using Optiwave simulation software Ver.10.0 for running simulation, this platform has been chosen to build a 40 Gb/s transmitted signal with and without equalizer. The schematic diagram for the proposed system of a 120 km transmission link including SMF-DCF fibers is described in Figure 5. Initially, four 10 Gb/s Transmitter are used and these four 10 Gb/s signals are multiplexed by using OFDM technique. Optical Amplifier system is used for one-span 60 km transmission fiber (including standards SMF and DCF) to compensate a group velocity dispersion. Furthermore, bit-error-rate is also calculated when equalizer is installed in order to prove the critical improvement when equalizer is used in the system. To investigate the limitation of 40 Gb/s system with and without equalizer by increasing number of spans means that transmission length would be increased for each situation. Constellation diagrams are also investigated for each situation at a value of receive power of approximately 40 dbm. From those constellation diagrams, significant improvement would be seen from transmitted system with equalizer, especially when the fiber length is increased.

   Figure 5 Hybrid OFDM/ WDM system; a) transmitter

   Figure 5: Hybrid OFDM/ WDM system b) Receiver

5. RESULTS AND DISCUSSIONS

   The system is analyzed here and the performance of system is checked with & without equalizers at 10 Gbps. The result for the transmitter part which is in electrical, frequency and optical domain was shown in the figures below from Figure 6.1 to Figure 7.3, these results shows the constellation diagram for 4 QAM encoder output, frequency domain OFDM signal, the signal after MZM modulator (hybrid Optical OFDM Signal) and the optical signal frequency domain in fiber link media.

   Figure6.1: 4 QAM Encoder Constellation Diagram

   Figure 6.2: Modulated OFDM Signal in Frequency Domain for each OFDM Channel.

   Figure 6.3 shows the Hybrid OFDM Signal (combination of each OFDM channel) after WDM MUX as shown in Hybrid OFDM system design in figure 5 (a). This signal is Optical in nature with 193.05, 193.1, 193.15, 193.2 (all in THz) frequencies of OFDM channel 1,2,3,4 respectively.

   Figure 6.3:(a) Hybrid OFDM Signal after WDM MUX.

   Figure 6.3: (b) Optical signal in the Fiber

   The result for the receiver part which is in electrical, frequency and optical domain was shown the figures below Figure 7.1 and Figure 7.2, these results show the received signal, output constellation diagram.

   Figure 7.1: Received signal after coherent detection

   After the clarified RF OFDM signal is achieved at OFDM demodulator and the demodulation operation is done, the output of the demodulator will analyze to achieve desired value of BER, the final constellation diagram is shown in Figure 7.2.

   1. Without equalizer

      1. With equalizer

         Figure 7.2: Final 4QAM Decoder constellation diagram

         1. System Results with transmission distance 240 km:

            In this section simulation results of OOFDM are presented keeping the system parameters same as mentioned in previous sections with transmission distance 240 km.

            1. Without Equalizer

            2. With Equalizer

         Figure 8: Final 4QAM Decoder constellation diagram with transmission distance 240 Km

6. CONCLUSION

   With the combination of the advantages from OFDM and QAM modulation, the system can be used for both short distance as well as long haul transmission at very high data rate. This improves the system flexibility and

   provides a very large coverage area of telecommunication networks without increasing the cost and complexity of the system very much. Also recently, it has been proved by many researchers that OFDM is better compared to the conventional single carrier modulation for long haul optical transmission.

   From the constellation diagrams it is clear that the nonlinearity increases as we increase the fiber length. The symbols shown in constellation diagram are become closer together resulting in a higher bit error rate and it limits the transmission performance of the system.

   And here it is also clear that the distance between symbols is increases in the COOFDM system having equalizer for the same transmission length.

7. References

[1]. S. Hara and R. Prasad, Multicarrier Techniques for 4G Mobile Commmications, (Artech House, Boston, 2003).

[2]. W. Shieh and C. Athaudage, Coherent optical orthogonal frequency division multiplexing, Electron. Lett. 42, 587 588 (2006).

[3]. Hellstrom, E., H. Sunnerud, et al.Third-order dispersion compensation using a phase modulator. Journal of lightwave Technology 21(5):1188-97, 2003.

[4]. Yammamoto, T., et al Third- and fourth-order active dispersion compensation with a phase modulator in a terabit-per second optical time- division multiplexing transmission, optic letters, 11 (9):647-49.

[5]. W. Shieh, H. Bao, and Y. Tang, Coherent optical OFDM: Theory and design, Opt. Exp., vol. 16, pp. 842859, Jan. 2008.

[6]. E. Ip, A. P. T. Lau, D. J. F. Barros, and J. M. Kahn, Coherent detection in optical fiber systems, Opt. Exp., vol. 16, pp. 753791, Jan. 2008.

[7]. G. P. Agrawal, "Nonlinear Fiber Optics, Second Edition",Academic Press, San Diego, USA, (1995) Chap. 10.